Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.
DEMOLITION AND SELLING
If it decides to not use more the machine because obsolete and/or irreparably damaged or worn about to bring anti economic
the reparation, it is necessary to proceed to its out of service bringing inactive and without potential dangers. The out of service
must be entrusted to specialized and equipped personnel.
Before beginning the demolition, signal that there are interventions in progress.
7.1. DEMOLITION
The main sequential phases for the disassembly and the dismantling include (not exhaustive indicative list):
1.
the sectioning device of the feeding external energy must be blocked with a padlock in the zero "0"
position. See for this aim the chapter 6;
2.
disconnect the conductors from all components presented inside the electric panel and from all
components installed on the machine and send them to corporations or waste separation societies in
accordance with the actual standard;
3.
disassembly all components included inside the electric panel and installed on the machine and send
them to corporations or waste separation societies in accordance with the actual standard;
4.
all metallic or plastic carcasses, the screws and any other part in steel or plastic must be sent to
corporations or waste separation societies in accordance with the actual standard.
All disconnecting operations must be performed using adequate equipment and tools of adequate sizes (for example cutting
or cross screwdriver, hexagonal wrench, allen spanners, etc...), in accordance with the screws to slacken.
At the end of the dismantling activities all identification labels and every other machine document must be destroyed.
7.2. SELLING
It is a user obligation to be acquainted of the actual laws about to the management of the electric and
electronic equipment refuses (RAEE), in its country and work so as to comply with these legislations.
The evaluation and the management for the biologic compatibility of the products used in the machine are of
user competence and responsibility
The machine can be sold without need to reduce in tiny pieces; it is sufficient to disconnect the main groups that made it and
place them on the means of transportation used to the scrapping.
The main duties being up to the user are the following:
1.
it is obligatory not to sell the RAEE as urban refuses, but occur to perform a separated harvest;
2.
for the RAEE selling it is possible to deliver to the distributor the electric equipment during the new one purchasing;
3.
In option for the selling, work in conformance with the actual standards, enquiring to the waste separation centers
prepared from the local administrations and/or to the firms specialized in the industrial machines scrapping and/or in the
refuses selling and/or rejob centers, treatment and recycling, in order that there is the separation between plastic
material, metallic material and electric components that must be sent to waste separations;
4.
in the machine dangerous substances aren't present that can have a potentially negative effect towards the
environment and the human health;
5.
a machine improper use or of its parts not determine a potentially negative effect towards the environment and the
human health;
6.
the symbol that shows the separated harvest need (
showed here under; the symbol is printed in visible way, readable and indelible on the product;
7.
the foreseen penalties, in case of abusive selling of these refuses, are defined from the actual and applicable legislation
where the product is eventually sold abusively: application of the administrative penalties in the article 50 and the next
of the D.Lgs. n. 22/1997.
10-2009-IMPASTATRICE-ART 2700-A5.doc
) is a rubbish crossed container on wheels as
ORIGINAL INSTRUCTIONS TRANSLATION
Pag.
di
29
30
Publicité
Chapitres
Table des Matières
