Transportation, Livening And Storage - IGF 2700/PL10/8 Mode D'emploi Et D'entretien

5.2. TRANSPORTATION, LIVENING AND STORAGE

All transportation and livening operations must be performed from personnel adequately informed and trained and must
have read and understood the safety prescriptions showed in the present instructions manual for the use.
Occur:
1. perform the machine livening and transportation always when it is unloaded;
2. verify that the lifting means are able to support the weight and the size of the loading in safety
conditions and that they are approved and submitted to a regular maintenance,
3. adopt all measures necessary to assure the maximum stability of means and loads in relation to their
masses and barycentres,
4. avoid to make suffer to the machine sudden shocks or accidental knocks during the livening and the
unloading,
5. perform the livening with continue movements, without pulls or repeated impulses.
STORAGE
The machine destined for the internal installation, in case of storage, must be stored in warehouse, in aired place, sheltered
from the dust. The delivered machine must remain packaged up to the final installation in the use place.
In case of long inactivity the machine must be stored with the precautions relative to the place and to the storage times:
1. Store the machine in a closed place;
2. Protect the machine from knocks and stresses;
3. Protect the machine from the humidity and from excessive thermal ranges (make reference to the under table);
4. Avoid that the machine is on contact with corrosive substances.
The machine has been designed so as to support the temperatures, the humidity and the transportation and storage vibrations.
-25 / +40 °C (if the electric material has a protection degree at least of IP54)
Environment
temperature
0 / +40 °C (if the electric material has a protection degree inferior to IP54)
-25 / +55 °C (if the electric material has a protection degree at least of IP54)
Storage temperature
0 / +55 °C (if the electric material has a protection degree inferior to IP54)
100% to the temperature of +25°C (if the electric material has a protection
Relative humidity
Inferior to 90% to the temperature of +20°C (if the electric material has a
Vibrations
Atmospheric
pressure
The storage temperature is intended as a short term values as for example the transportation. The condense or the freezing
happen normally in places where the temperature jolts are high. Also if the relative humidity in these cases can be included in
the values showed in the table, it is necessary avoiding these places.
CONTROLS DURING THE RECEIVING
It is very important to perform a good control during the parcels incoming, in the same moment of their receiving. The
control performs in two phases for every parcel received with the aim to avoid possible errors of the carrier.
Administrative verification
1. Container and parcels number;
2. Weight and size;
3. Transportation document information correspondence with what delivered (description, registration number, etc. The
technical data on the machine identification plate correspond with those ones included in the delivered technical
documentation);
4. Transportation document data corresponding to the order.
Technical verification
1. Package condition and integrity.
2. The package has not suffered visible damages, in the transportation and livening operations.
In case of damages or incomplete or mistaken supplying, signal the fact directly to the manufacturer commercial department.
For what above described, the manufacturer remembers to the user that, for the current international and
national standards, the goods travels always with risk and danger of this last one and, if not differently
underwritten in the order confirmation phase, the goods travels not ensured.
10-2009-IMPASTATRICE-ART 2700-A5.doc
degree at least of IP54)
Inferior to 50% to the temperature of +40°C
protection degree inferior to IP54)
2
5.9 m/s (0.6G) or bigger
900 mbar or bigger
ORIGINAL INSTRUCTIONS TRANSLATION
Avoid places in which
unexpected
temperature jolts that
can provoke condense
or freezing
Pag. di
17 30