Mounting The Drive Unit - GILGEN ASL-S Instructions D'installation Et D'utilisation

2.5.2

Mounting the drive unit

- Using the three hexagon head cap screws M10 x 25 and the dowels, mount the Halfen frame onto the wall.
- Push the spacer block (27) onto the output shaft, the chamfer pointing towards the ball-bearing and the chain
pinion (26).
Attention:
Do not damage the serration toothing
- Tighten the flat head screw M8 x 16 (33) of the spacer block (27), the chain pinion (26), the counter sunk washer
(32) on the output shaft (4).
21
36, 37
35
37, 36
- Pos 36: Sliding nut with hexagon head cap screw M10 x 20 and washer. Fig. 29
- Pos. 37: Halfen screw with washer and nut M10. Fig. 29
- Screw the screws (36) / the Halfen screw (37) loosely onto the drive unit; arrangement depending on the chain
exit.
Note:
The chain stretching angle (35) Fig. 29, Fig. 30, must always be clamped on the side where
no chain is passing.
- Push the drive unit (21) from one side into the mounted Halfen frame (13).
- Place the U-shaped profile (38) on the Halfen frame (13). Mount the tension screw (39) with the securing nut (40).
Fig. 30
38
0602-999-11c_2008.09.p65
27 26 4 32, 33
Chain drive
system left
39 13 40
0602-999/11c
ASL-S
20-40
73
A
A
35
Section
37, 36
A - A
13
36, 37
Fig. 29
Fig. 30