Mounting The Drive Unit - GILGEN ASL-S Instructions D'installation Et D'utilisation

Z 238
- Using three hexagon head cap screws M10 x 25 and the dowels, fasten the Halfen frame (13) to the ceiling.
2.3.2

Mounting the drive unit

- Push the spacer block (20) onto the output shaft, the chamfer pointing towards the ball-bearing and the toothed
belt pulley (19).
Attention:
Do not damage the serration toothing.
- Using the flat head screw M8 x 16 (33) , mount the spacer block (20), the toothed belt pulley (19), and the
countersunk washer (32) on the output shaft (4).
36, 37
35
37, 36
0602-999-11c_2008.09.p65
29 13
29
Z 136
21 19 32, 33
Belt exit on
the left
255
16
4 34 20
0602-999/11c
ASL-S
10-40
255
70
15
A
37, 36
13
36, 37
A
Fig. 9
Fig. 10
Section
A - A
Fig. 11