Push-Pedal" Foot Control - CASTELLINI SKEMA 6 CART Instructions De Service

5.2.2. "Push-pedal" foot control

Description of the parts
1 Handle
2 Control pedal
3 Dental chair movements
4 Chip-air/patient rinsing position control
5 Water Clean System/Automatic dental chair return control
6 Spray operation LED
7 Battery charge LED (wireless version only)
Control pedal ( 2 )
Operation:
• Remove the instrument
• Push the foot pedal to start the instrument ( a )
• Adjust the rpm/power of the instrument with the control pedal:
- to right: to increase
- to left: to decrease
NOTE: the control pedal adjusts the speed/power of the instrument
from the minimum to the maximum value set from the instrument board.
• To stop the instrument, simply release the control pedal ( a ).
NOTE: with spray, at the end of work a blast of air is automatically
activated to eliminate any residual drops of liquid in the instrument ducts.
WARNING!
Instrument spray is activated or deactivated by pressing the buttons
( 4 ) or ( 5 ).
A beep sounds to signal the operating status has been changed.
When the LED ( 6 ) is on, it indicates operation with spray.
Dental chair buttons ( 3 )
These buttons move the dental chair as follows:
Dental chair seat up.
Dental chair backrest up.
Dental chair seat down.
Dental chair backrest down.
To stop movement, release the button.
NOTE: all the buttons used to move the dental chair are inoperative
when an instrument is removed and the foot control pedal is actuated.
Left-hand button operation ( 4 ).
Operation:
• Holding down the button for at least 2 seconds with the instruments in
rest position:
Activation of the "Patient rinsing position" program.
NOTE: pressing the button a second time returns the dental chair
into working position.
• Holding down the button for at least 2 seconds with instrument extracted:
Chip-air control: sends a jet of air to the turbine or the micromotor.
Air delivery is activated by pressing the button; the jet of air is interrupted
when the button is released.
NOTE: the control works only when the turbine and micromotor
are in working position.
• Briefl y pressing the button with the instrument extracted:
Instrument spray activation or deactivation.
WARNING!
A short acoustic signal warns of the switch.
When the LED ( 6 ) is on, it indicates operation with spray.
110 110 110 GB EN
SKEMA 6
- OPERATING INSTRUCTION