Yamaha RS90K Manuel D'atelier page 310

2
1
a
2
DRIVE CHAIN HOUSING
2. Install:
• Lever rod 1
3. Adjust:
• Lever rod length a
Adjustment steps:
• Loosen the locknuts 2.
• Turn the lever rod 1 in or out until the specified
length is obtained.
Lever rod length:
27 mm (1.06 in)
• Tighten the locknuts.
4. Install:
• Shift rod 1
5. Adjust:
• Shift rod length a
Adjustment steps:
• Move the shift lever to the "FWD." position.
• Loosen the locknuts 2.
• Turn the shift rod 1 so that shift rod free play is
0 mm (in direction where a can be lengthened
appropriately) and then turn back the shift rod
1/2 turns.
• Tighten the locknuts.
6. Fill:
• Drive chain housing oil
Refer to "DRIVE CHAIN" in CHAPTER 2.
7. Adjust:
• Drive chain slack
Refer to "DRIVE CHAIN" in CHAPTER 2.
4-26
POWR
TR