Yamaha RS90K Manuel D'atelier page 198

FRONT SUSPENSION/REAR SUSPENSION
1
1
2
No.1
No.2
No.3
No.4
No.5
No.6
2-75
CAUTION:
Be sure that the left and right spring preloads
are the same.
WARNING
These shock absorber contain highly pressur-
ized nitrogen gas.
Do not tamper with or attempt to open the
shock absorber assemblies.
Do not subject the shock absorber assemblies
to flames or high heat, which could cause it to
explode.
REAR SUSPENSION
Stopper band (RS90/RS90R/RS90M/RST90/
RST90TF)
1. Adjust:
• Stopper band length
CAUTION:
Make sure the left and right rear suspension
stopper bands are adjusted evenly.
NOTE:
This adjustment affects the handling characteristics
of the machine.
Adjustment steps:
• Remove the stopper band bolts 1, nuts and
washers.
• Adjust the length of the stopper bands by insert-
ing the bolts in different holes 2.
Standard setting:
No. 1 hole
• Tighten the stopper band nuts.
Stopper band nut:
4 Nm (0.4 m · kg, 2.9 ft · lb)
INSP
ADJ