Yamaha RS90K Manuel D'atelier page 230

È É
STEERING
3. Install:
• Tie rod 1
• Locknuts 2
• Joints 3
Tie rod part
number
8ES-23830-00
(RS90/RS90R/ 424.0 mm
RSG90/RST90/ (16.70 in)
RST90TF)
8FW-23830-00 374.0 mm
(RS90M) (14.72 in)
4. Check:
• Tie rod angle a
Tie rod angle:
47°
CAUTION:
After tightening the inside and outside ball joint
locknut 2, make sure the tie rod 1 can be
rotated freely through the ball joint travel. If not,
loosen the locknut 2 and re-position the ball
joint so that the tie rod 1 can be rotated freely.
Tighten the locknut to specification.
È Left side
É Right side
5. Install:
• Tie rods 1
NOTE:
• Make sure that the indentation a on the tie rod
faces out.
• The threads on both rod ends must be the same
length.
CAUTION:
Always use new cotter pins.
Tie rod end locknut:
25 Nm (2.5 m · kg, 18 ft · lb)
LOCTITE
Tie rod-idler arm nut:
30 Nm (3.0 m · kg, 22 ft · lb)
Tie rod-steering arm nut:
35 Nm (3.5 m · kg, 25 ft · lb)
6. Bend the lock washer tab along a flat side of the
bolt.
3-9
CHAS
Tie rod
Set length a
length b
361.0 mm
(14.21 in)
311.0 mm
(12.24 in)
®