Electrical; Headlight Beam Adjustment; Battery Inspection - Yamaha RS90K Manuel D'atelier

HEADLIGHT BEAM ADJUSTMENT/

BATTERY INSPECTION

ELECTRICAL

HEADLIGHT BEAM ADJUSTMENT
1. Place the machine on a level surface.
2. Place the machine in front of a wall at the rec-
3. Measure the distance H from the floor to the
4. With a person sitting on the machine, apply the
5. Switch on the headlight's high beam and check
D
S
D: Distance
6. Adjust:
BATTERY INSPECTION
Batteries generate explosive hydrogen gas and
contain electrolyte which is made of poisonous
and highly caustic sulfuric acid. Therefore,
always follow these preventive measures:
• Wear protective eye gear when handling or
working near batteries.
• Charge batteries in a well-ventilated area.
• Keep batteries away from fire, sparks or open
flames (e.g., welding equipment, lighted ciga-
rettes).
• DO NOT SMOKE when charging or handling
batteries.
• KEEP BATTERIES AND ELECTROLYTE OUT
OF REACH OF CHILDREN.
• Avoid bodily contact with electrolyte as it can
cause severe burns or permanent eye injury.
2-44
ommended distance D. Refer to the table
below.
center of the headlight and place a mark on the
wall at that height.
parking brake, start the engine and let it idle.
the height of the projected beam on the wall.
The projection should be at the position marked
in step 3 or 1/2° lower (set range S).
3.0 m (10 ft)
26 mm (1.0 in)
H: Height
• Headlight beam (vertically)
Vertical adjustment
Higher Turn the adjusting bolt 1
clockwise.
Lower Turn the adjusting bolt 1
counterclockwise.
WARNING
INSP
ADJ
7.6 m (25 ft)
66 mm (2.6 in)
S: Set range