Annual Inspection; Electrical Safety Test - WORLD OF MEDICINE PP110 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 121
10

Annual Inspection

The manufacturer stipulates that qualified personnel or hospital technicians
must regularly test the device to assess its functionality and technical safety.
These inspections have to be carried out on an annual basis. Regular inspections
will assist in early detection of possible malfunctions. This helps preserve the de-
vice and increases its safety and service life.
The tests described in this chapter are designed specifically for trained personnel
or a hospital technician. The operation of the device as well as its functionality
and serviceability are easily checked. Each test conducted must be documented
with date and signature in chapter 15.1 "Test Log".
Each test conducted must be documented with date and signature on the test log
(chapter 15 "Test Log").
The following measuring tools and resources were used by the manufacturer to
determine the measurements and tolerance levels:
Tube set
Beaker/meas. cup
2 fluid bags
Suction tubes
Suction container
Instrument
Stop-watch
WARNING!
An authorized service technician must check the device if the specified parame-
ters and tolerances are exceeded.
10.1

Electrical Safety Test

1. Perform a visual inspection. Make sure
• the fuse corresponds with the specifications indicated by the manufactur-
er,
• labels and stickers on device are legible,
• the mechanical condition of the device allows for its safe use,
• the device is clean to ensure proper and safe functionality.
2. Carry out the measurements for the device leakage current and the protec-
tive conductor resistance as per IEC 62353 in the current version or according
to the applicable national standard (possible measuring points: metal edges
around the non-heating device plug for mains connection. See (17) Fig. 5-2
"Device rear").
with scaling up to 2.0 l
Vacuum tube, drain tube
3.0 l
Trumpet valve or stopcock
Annual Inspection
Manufacturer's specification
Inspection tests
Measured Values and Tolerances
en
43

Publicité

Table des Matières
loading

Table des Matières