Mounting On Stand - WORLD OF MEDICINE PP110 Mode D'emploi

Initial Device Startup
en
Fig. 4-1

Mounting on Stand

14
4.2.1 Mounting on Stand
WARNING!
Please read the instruction manual for the stand before mounting the pump on
the stand.
WARNING!
The position of the device on the stand can affect the stand's stability. If the de-
vice is mounted too high on the stand, the stand may tilt or topple. The user/op-
erator of the device is responsible for making sure the device cannot be tipped
over or otherwise become unstable.
1. Position the pump on the rod of the stand at the desired height, usually be-
tween 80 and 120 cm (example: Base of stand ø = 65 cm, max. height of
h < 100 cm recommended).
2. Tighten the toggle screw on the rear of the pump.
NOTE!
Make sure the toggle screw is tightened sufficiently to fasten the pump securely
in place. Also check that the toggle screw remains tightened.