Suction - WORLD OF MEDICINE PP110 Mode D'emploi

output is available for the next irrigation procedure.
7. Press the irrigation START/STOP key again (LED goes out).
The tube is now relieved of pressure. The roller wheel spins backwards
5.10

Suction

(1)
(1) (2)
The suction system consists of the following:
• Vacuum tube
• Hygiene filter
• Suction container
• Irrigation tube
• Standard instrument or suction/irrigation instrument
1. Connect device with the suction container (using vacuum tube and hygiene
filter). The vacuum tube set with hygiene filter can remain connected to the
device for max. 30 days (Fig. 5-16 "Connect device with the suction system
with suction-/Irrigation instrument").
2. Connect suction container with instrument (using irrigation tube Fig. 5-16
"Connect device with the suction system with suction-/Irrigation instru-
ment").
Close stopcock if using instrument with stopcock.
3. Press the suction START/STOP key (LED lights up).
The device generates a negative pressure inside of the suction system. The
vacuum pump stops when a negative pressure of max. -60 kpa (-0.60 bar) has
been reached.
The vacuum pump automatically reactivates, if the min. negative pressure is
reached.
4. Starting suction:
Actuate the trumpet valve or open the stopcock.
5. Stopping suction:
Release the trumpet valve or open the stopcock.
6. Press the suction START/STOP key again (LED goes out).
CAUTION!
The full suction output/volume is available only, if the suction system is pre-
evacuated (vacuum generation). Pre-evacuation takes about 20 to 60 seconds
(2) (4)
(3)
(3)
(5)
Fig. 5-14 Suction system with suction-/
Irrigation instrument
Vacuum tube set with hygiene fil-
(1)
ter
Suction container
(2)
Suction tube
(3)
Irrigation tube
(4)
Instrument
(5)
(4)
Fig. 5-15 Suction system with standard
instrument
Vacuum tube set with hygiene fil-
(1)
ter
(2) Suction container
Suction tube
(3)
Standard instrument
(4)
Fig. 5-16 Connect device with the suc-
tion system with suction-/Irri-
gation instrument
Operating the Device
27
en