Publicité
Les langues disponibles
Les langues disponibles
User manual
The chest belt
The computer is equipped with a built-in receiver, which can (alternatively to the handpulse
measurement) receive your pulse frequency through the included chest belt.
Measuring the pulse frequency via chest belt enables you to exercise without constantly holding
the handpulse sensors. However, please pay attention that a body fat measurement is only
possible when using the handpulse sensors.
Make sure, the correct battery is inserted into the breast strap (type CR-2032, 3 volts).
You may adjust the strap to a comfortable length. However, the electrodes must have contact with
your skin in order to measure your heart rate correctly. It may last up to one minute before a
correct display can be seen.
Fix the elastic strap on the transmitter. Guide the round buckle through the opening on one end of
the transmitter.
Hint: Moisten the electrodes slightly before wearing the strap. This increases
the contact sensibility and enables a better wireless signal transmitting.
Safety hint: Do not use the pulse-measurement (breast strap system)
if you have a pacemaker, unless you double-checked with the producer
of the pacemaker and with your doctor!
Battery replacement
The chest belt needs a button cell battery CR2032 3V. If the pulse frequency is not measured
correctly anymore you should exchange the battery. Open the battery compartment on the back
side of the belt (e.g. with a coin). Replace the battery by a fitting new one of the same type and
close the battery compartment.
57
Publicité
