U.N.O. Fitness Motive Fitness CTX 2000 Instructions De Montage Et D'utilisation page 47

User manual
Mains connection
The computer gets its power supply by the included
adaptor which will be connected to a normal mains
plug (European standard, please check the
specifications). If you have to buy a new adaptor it is
important to pay attention that it is GS-approved and
corresponds to the product safety law and the below
mentioned specifications.
The adaptor will be connected to the little plug in the
cover of the item near by the rear stabilizers.
Adaptor specifications:
Input: 230V~50Hz./0,1A max.
Output: 9V 500mA 4.5VA
Don't use another electricity supply because this could cause damages or impairments of
functions. Please pay attention to the adaptor specifications on the type plate!
Computer operating instructions:
The multi-functional training computer has many operation modes and shows you all important
training data for your personal exercise surveillance.
It is very important to read all instructions completely in order to avoid faults and
misunderstandings and to exercise optimally with your new ergociser. Thank you!
The computer starts working by using the pedals or pressing the button.
The computer will switch on automatically when pedalling. After app. 4 minutes without any
activity the computer will also automatically switch off to save energy.
Hint
The computer is equipped with a built-in receiver, which can receive the pulse signals measured
by the included breaststrap wirelessly.
Function buttons:
„MODE"
„RESET"
„UP" / „DOWN"
„START/STOP"
„RECOVERY"
„BODY FAT"
F
To confirm different settings, further explanations will follow.
To clear set-up values. Press and hold the button for approx.
4 seconds to execute a full reset (all values will be set to 0)
To select training mode and adjust values up/down,
we will explain more detailed later on.
To begin or end en exercise session
Starts the heart recovery rate measurement
Starts the body fat measurement
47
101