Observe The Following Instructions For The Ed07 Pressure Regulator - Aventics ED07 Mode D'emploi

46 AVENTICS | ED07 | R41400766–BDL–001–AB
For your safety
Signal word
CAUTION
NOTICE
General instructions
Before assembly
During assembly
The signal words have the following meanings:
Application
potentially hazardous
Indicates a
avoided, could result in minor or moderate injury or damage to
the equipment.
Indicates damage that may be inflicted on the product or the
environment.
2.5 Observe the following instructions for the
ED07 pressure regulator
Observe the regulations for accident prevention and
environmental protection for the country where the product is
used and at the workplace.
Do not change or modify the device.
Only use the device within the performance range provided in
the technical data.
Do not place any mechanical loads on the device under any
circumstances. Never use the device as a handle or step. Do
not place any objects on it.
Let the device acclimate itself for several hours before
installation, otherwise water may condense in the housing.
Make sure the relevant system component is not under
pressure or voltage before assembling or when connecting
and disconnecting plugs. Make sure the system cannot be
switched on accidentally. Hang signs on the main switch that
warn workers against switching the system on.
Always mount the ED07 pressure regulator on a base plate.
The ED07 subbase (order no. 5610211052) must be used for
devices with a pressure range of 16/20 bar.
Lay the cables so that no one can trip over them.
situation, which, if not