Hangar 9 Cub Crafters XCub 60cc Manuel D'utilisation page 24

Les langues disponibles

129. Install the receiver in the fuselage. Mount any remote

receivers in the fuselage using hook and loop tape. Follow

the instructions included with the receiver for the correct

locations for the remote receivers.

Î Apply a small amount of 5-minute epoxy to the

hook and loop tape to secure it to the radio tray.

130. Remove the covering from the fuselage side using a hobby

knife and #11 blade. Mount the switch using the hardware

provided with the switch.

Î The radio and ignition switch can also be installed in the

cockpit floor. Some event regulations may require the switches

be located so they can be accessed in an emergency.

131. Open the side door by rotating the lever counterclockwise.

132. Use a 2.5mm hex wrench to remove the screws securing the

cockpit loor.

133. Remove the loor and set it aside.Route the leads for the

ailerons and laps through the cockpit loor. Secure the leads

using tie-wraps, tape, or any other preferred method to

prevent them from interfering with the operation of the model.

www.modellmarkt24.ch;

‰ RUDDER PULL-PULL CABLE INSTALLATION

134. Thread a ball end eight turns on each of the four cable

ittings.

135. Use the radio system to center the rudder servo. Place

the rudder servo arm on the servo so two of the arms are

perpendicular to the servo centerline. Remove the two arms

that are parallel to the servo centerline using side cutters.

136. Enlarge the holes that are 5/8 inch (16mm) from the center

of the servo using a pin vise and 1/8-inch (3mm) drill bit. The

rod ends will attach to these holes.

137. Attach two of the rod ends to the rudder servo arm using

two M3 x 10 socket head cap screws, two M3 locknuts and

two M3 washers. Tighten the hardware using a 2.5mm hex

wrench and 5.5mm nut driver.

138. Insert the ends of the cables into the tubes in the fuselage.

Use low-tack tape to keep the cables from entering the tubes.

www.modellmarkt24.de

5/8 inch

(16mm)