Publicité
Les langues disponibles
Les langues disponibles
21. Fit the servo between the servo mounting tabs in the aileron
servo tray. The servo arm will be centered in the slot. Mark
the locations for the servo mounting screws using a pencil,
then remove the servo.
22. Use a drill and a 5/64-inch (2mm) drill bit to drill the holes
for the servo mounting screws in the locations marked in the
previous step.
23. Thread a servo mounting screw into each of the holes in the
servo mounting holes. Remove the screws, then apply a small
amount of thin CA to harden the threads made in the previous
step. After the CA has fully cured, secure the servo to the
cover using the screws provided with the servo.
24. Secure a 24-inch (600mm) servo extension to the servo using
a commercially available retainer (SPMA3054).
25. Tie or tape the string located inside the wing to the end of the
servo lead.
www.modellmarkt24.ch;
www.modellmarkt24.ch;
Cub Crafters XCub 60cc
26. Use the string to pull the servo lead through the wing and out
at the root.
Î We left a small amount of the string on the aileron
servo lead so it can be quickly differentiated between
the flap servo lead that will be installed later.
27. Secure the servo to the wing using four M2.5 x 10 self-
tapping screws. Use a #2 Phillips screwdriver to tighten the
screws.
28. Use two rod ends and the 6 inch (152mm) threaded linkage
to construct two aileron pushrods. Thread the rod ends evenly
on the threaded rod. Start with the linkage the length shown
in the photo.
29. Attach one end of the linkage to the control horn using two
M3 washers, an M3 x 15 socket head cap screw and an M3
lock nut. Tighten the hardware using a 2.5mm hex wrench
and 5.5mm nut driver.
Î Do not over-tighten the hardware and
damage the control horn or ball end.
30. Attach the opposite end of the linkage to the servo arm using
the hardware provided with the servo arm. Connect the
radio system to the servo and center the servo. Adjust the
linkage as necessary to center the aileron when the servo is
centered.
Î Repeat this section for the remaining aileron servo.
www.modellmarkt24.de
www.modellmarkt24.de
13
EN
Publicité
