Publicité
Les langues disponibles
Les langues disponibles
89. Cut two pieces of card stock that are 1/2 x 2 inches (13 x
25mm). Make a 1/8-inch (3mm) hole in each piece. Tape the
card stock to the fuselage with the hole aligned with the blind
nut in the fuselage.
90. Slide the fairing on the strut. Trace around the struts using a
felt-tipped pen.
91. Use a hobby knife and #11 blade, hobby scissors and a rotary
tool with a sanding drum to trim the fairing so the struts can
be reattached to the fuselage.
Î Be careful not to chip or damage the
paint on the strut fairing when cutting.
92. Hold the fairing tightly against the fuselage. Use a felt-tipped
pen to mark the locations for the mounting screws on the
fairings.
93. Disconnect the struts and remove the fairing. Use a pin vise
and 1/8-inch (3mm) drill bit to drill the mounting holes in the
fairing.
www.modellmarkt24.ch;
www.modellmarkt24.ch;
EN
94. Fit the fairing back on the strut. Attach the struts to the
fuselage, then attach the fairing to the fuselage using two M3
x 15 socket head cap screws and two M3 washers. Tighten
the screws using a 2.5mm hex wrench.
Î Place a drop of canopy glue on the screws before
installation. This will keep the screws from vibrating loose
yet leave them easily removable to disassemble the model.
‰ STABILIZER INSTALLATION
95. Place a small piece of tape on the bottom of the stabilizer and
elevator for identiication.
96. Separate the elevators from the stabilizer. Remove all the
hinges.
97. Place the stabilizer on the fuselage. Center the stabilizer on
the fuselage.
Î The elevator can be left in position
to aid in centering the stabilizer.
98. Stand back 8-10 feet (2-3 meters) and check that the
stabilizer is aligned with the wing. Lightly sand the stabilizer
saddle on the fuselage to correct any misalignment.
www.modellmarkt24.de
www.modellmarkt24.de
20
A
A
A=A
A
A
A=A
Publicité
