Télécharger Imprimer la page

Hangar 9 Cub Crafters XCub 60cc Manuel D'utilisation page 15

Publicité

Les langues disponibles

Les langues disponibles

41. Check the operation of the lap using the radio system. Trim
the sheeting using a hobby knife and #11 blade if any of the
hardware contacts the sheeting.
42. Secure the servo to the wing using four M2.5 x 10 self-
tapping screws. Use a #2 Phillips screwdriver to tighten the
screws.
Î Be careful not to press too hard and damage the structure.
43. Connect the lap servo to the radio system. Move the switch
on the transmitter to the "UP" lap position. Adjust the radio
setting to align the lap with the trailing edge of the wing
making sure the aileron is centered. The wing tip can be
used as a guide for aligning the aileron, or step back and look
directly at the trailing edge of the wing to make sure the lap
and aileron are aligned.
44. Move the switch at the transmitter to the "MID" lap position
of 15/16 inches (24mm). Adjust the radio settings to achieve
the setting for mid lap.
45. Move the switch at the transmitter to the "FULL" lap position
of 2
/
inches (70mm). Adjust the radio settings to achieve the
3
4
setting for full lap.
www.modellmarkt24.ch;
www.modellmarkt24.ch;
Cub Crafters XCub 60cc
46. Use hobby scissors or a hobby knife with a new #11 blade to
trim the lap linkage cover. Use care not to chip or damage
the paint.
47. Use canopy glue or contact adhesive to attach the lap linage
cover to the top of the wing. Use low-tack tape to hold the
cover in position until the adhesive fully cures. Make sure to
operate the laps with the fairing in place to make sure fairing
does not interfere with the linkage and cause the fairing to
come loose during operation of the laps.
48. Use canopy glue or contact adhesive to attach the wing light
cover to the of the wing. Use low-tack tape to hold the cover
in position until the adhesive fully cures.
Î Do not use CA as it will fog the lens.
‰ WHEEL ASSEMBLY
49. Place one of the aluminum wheel hubs in the center of the
tire.
50. Align the hub so the holes in the center align with the notches
in the tire.
www.modellmarkt24.de
www.modellmarkt24.de
15
EN

Publicité

loading