Control System; Throttle Cable - SELVA MARINE Goldfish 4 Manuel D'entretien

INSP
ADJ
3

CONTROL SYSTEM

503012
1
2
CONTROL SYSTEM

Throttle cable

NOTE:
Make sure to check the idling speed, after
adjusting the throttle cable.
1. Inspect:
9 Throttle cable
Slack ® Adjust.
Damage ® Replace.
2. Adjust:
9 Throttle cable set condition
Adjustment steps:
8 Turn the throttle grip in arrow direc-
tion and hole to fully closed position.
8 Enough to loosen the throttle stop
screw 1.
8 Loosen the throttle cable locking
screw 2 and keeping the throttle
lever on the carburetor fully in the
closed position by turning in arrow
direction.
8 Check the throttle cable 3 with no
(noticeable) slack, then tighten the
throttle cable locking screw 2.
8 Make sure the throttle lever on the
carburetor fully open and fully closed
in operation by turning the throttle
grip.
8 If the throttle lever does not operate
in the fully opened position, re-adjust
the throttle cable.
3-3
E