Table des Matières
Publicité
INSP
CONTROL SYSTEM
ADJ
All manuals and user guides at all-guides.com
Idle speed adjustment
Start-in-gear protection device adjustment
3-3
1. Measure:
Idle speed
Out of specification → Adjust.
Idle speed:
925 ± 50 r/min
Measuring steps:
Start the engine and allow it to warm
up for a few minutes.
Attach the tachometer to cylinder #1's
spark plug lead.
Tachometer:
90890-06760
2. Adjust:
Idle speed
Adjustment steps:
Turn the throttle stop screw 1 in direc-
tion a or b until the specified idle
speed is obtained.
Direction a
Idle speed increases.
Direction b
Idle speed decreases.
1. Check:
Start-in-gear protection device opera-
tion
Incorrect → Adjust.
2. Adjust:
Start-in-gear protection wire
Adjusting steps:
Set the shift lever in the neutral posi-
tion.
Loosen the screw 1.
Move the adjusting plate 2 until the
point a on the wire connector aligns
with the mark b in the flywheel cover.
Tighten the screw.
E
Publicité
Table des Matières
