Cylinder Head - SELVA MARINE Goldfish 4 Manuel D'entretien

POWR
4
CYLINDER HEAD AND PUSH ROD
2
3
2
1
SERVICE POINTS
NOTE:
Cylinder head maintenance is possible
with the power unit mounted.
Cylinder head removal
1. Remove:
Bolt 1 (M6 x 45 mm)
9
Bolt 2 (M8 x 60 mm x 3)
9
Bolt 3 (M8 x 40 mm x 1)
9

Cylinder head 4

9
NOTE:
Insert a flat-head screwdriver between the
tabs on both side of the cylinder and cylin-
der head and pry open the two parts.
cC
Do not scratch the interface of cylinder
and cylinder head.
Cylinder head inspection
1. Measure:
9 Cylinder head warpage
Out of specification ® Resurface or
replace the cylinder head.
Warpage limit:
0.1 mm (0.004 in)
Resurfacing steps:
8 Place a 400 ~ 600 grit wet sandpaper
on the surface plate.
8 Resurface the cylinder head using a
figure-eight sanding pattern.
To ensure an even surface, rotate the
cylinder head several times.
NOTE:
To ensure an even surface, rotate the
cylinder head several times.
5-13
E