SELVA MARINE Goldfish 4 Manuel D'entretien page 196

POWR
2
1
CRANKCASE, CRANKSHAFT AND CAMSHAFT
a
Measurement steps:
cC
Make sure that the
mark 1 1 is aligned with the "D" cap
mark 2 2 .
8 Clean the cap and big end contact
surface of the connecting rod.
8 Fit the connecting rod to the crank-
shaft.
8 Put a piece of Plastigauge
crank pin.
8 Assemble the connecting rod cap on
to the crank pin.
NOTE:
Make sure that the "YAMAHA" mark a
9
on the connecting rod faces upwards
on the flywheel rotor ass'y.
9 Do not move the crankshaft until big-
end oil clearance measurement has
been completed.
8 Apply motor oil to the bolts and the
bolt seat.
8 Tighten the bolts to the specified
torque.
Bolt: (connecting rod cap)
12 Nm (1.2 m•kg, 8.7ft•lb)
8 Remove the connecting rod cap.
8 Measure the width of the com-
pressed Plastigauge
pin.
5-35
E
"Ñ" connecting rod
® on to the
on the crank
®