Nanosonics trophon 2 Mode D'emploi page 19

Note: The list of available Wi-Fi networks on the trophon2 device will not include unsecured networks.
To disconnect from the Wi-Fi network, toggle the Wi-Fi status to OFF.
To display the network properties, select the connected network, then select Properties. On this page,
select 'forget' to forget the network credentials. This will also disconnect from the network and username
password will be forgotten.
Nanosonics recommends the use of Wi-Fi only when ethernet is unavailable and a
network connection is required. Nanosonics does not recommend simultaneous
connection to both Ethernet and a Wi-Fi network.
B2.7 AcuTrace
AcuTrace is an automated HLD traceability system that uses Radio Frequency Identification (RFID).
AcuTrace-enabled consumables and accessories contain RFID chips that store information and can be
read by the built-in AcuTrace reader on the trophon2 device.
Each medical instrument (ultrasound probe) is allocated a trophon AcuTrace Medical Instrument Tag
and individual trophon2 operators are assigned a trophon AcuTrace Operator Card. This is important to
meet compliance documentation requirements in many regions.
The reprogramming of Medical Instrument Tags and Operator Cards is not recommended, as
this may impact the disinfection traceability system.
The trophon2 AcuTrace reader is located on the device as shown:
Figure 9. The AcuTrace Reader
AcuTrace-compatible products that have an embedded RFID chip can be
identified by this symbol:
Scan the symbol on the AcuTrace reader when prompted.
19
L03082 4.0 01/2023