Nanosonics trophon 2 Mode D'emploi page 18

5. Choose 12- or 24-hours clock and select SAVE.
NTP provides your trophon2 device with Co-ordinated Universal Time (UTC). Your device will use this
to calculate the time in the local timezone that has been set. The time setting will periodically synchronise
with the UTC. The device will update the time when DST starts and ends according to the timezone set.
Printer label
Select the number of printer labels; up to 4 records can be printed.
Daily timers
Configure a preset daily wake and sleep time.
Brightness and Alarm
Configure the brightness of the trophon2 touch screen and the volume of the trophon2 device alarm.
Network
Network access is required to allow for automatic time setting.
Consult your facility's IT administrator or network parameters expert to complete this setting.
The trophon2 device can be connected to a network via the Ethernet port or to a wireless network by a
USB Wi-Fi adapter.

Ethernet
The device supports the Transmission Control Protocol (TCP)/ Internet Protocol (IP). You can set a
static IP address, or you can use the Dynamic Host Configuration Protocol (DHCP), which directs the
router to assign a valid IP address. Select:
 
Menu Settings Network
Then select Static IP or DHCP. If you use a static IP address, the screen will request network
parameters. Your network administrator can provide an IP address that is not in use and will advise
appropriate values for the subnet mask and the default gateway.

USB Wi-Fi Adapter
The trophon2 device can be connected to a Wi-Fi network using a USB Wi-Fi adapter.
one USB Wi-Fi Adapter to trophon2.
Nanosonics recommends the use of the TP-Link TL-WN725N or TP-Link TL-WN72N USB Wi-Fi
adapters.
Alternative USB Wi-Fi adapters may be used however, they must meet the following specifications to
be compatible with the trophon2 device:

Wireless Standard: 802.11N

USB Type: USB 2.0

Linux Compatibility: Kernal 2.6 or later

Certifications: RoHS & WEEE

Network security: WPA2-Personal and WPA2-Enterprise

Chipset: Realtek RTL8188EUS
To activate the USB Wi-Fi adapter, select:
 
Menu Settings Network
Connect a compatible USB Wi-Fi adapter to one of the 3 x trophon2 USB ports (see section B1.1
Features of the trophon2 Device). Turn ON the Wi-Fi status and select the desired Wi-Fi network. The
trophon2 device will prompt operators to input login credentials for first time connection to a network.
The trophon2 device automatically connects to the Wi-Fi network if a compatible USB adapter is
connected and the Wi-Fi network has been previously selected.

Ethernet

Wi-Fi
18
L03082 4.0 01/2023
Only connect