Nanosonics trophon 2 Mode D'emploi page 16

Figure 8. Suggested Mounting Height
B2.2 Powering On
The trophon2 device must not be connected to the same circuit as critical patient or life
support equipment.
1. Attach the power cable supplied to the power socket of the trophon2 device.
2. Connect to mains power.
3. Turn on the power switch, located on the left side of the trophon2 device.
NOTE: Keeping the trophon device connected to power allows it to go to sleep automatically. While the
trophon device is in sleep mode, it will perform self-maintenance functions.
B2.3 Initial Setup
The Initial Setup launches automatically, prompting you to configure the optional settings when turning
on the trophon2 device for the first time. Follow the onscreen instructions.
Figure 7
16
L03082 4.0 01/2023
Distance on each side of the
trophon2 device:
A = 250 mm (10 in)
B = 250 mm (10 in)
(not to scale)