Publicité
Guide d'installation
teleCARE IP
Kadex Interface to NIRC3 Connection
Connect the NIRC3 to the Kadex Interface using a USB (type A to Type B) cable.
(1) Plug the USB (Type A) connector into the top slot of the USB 2.0 socket on the NIRC3.
(2) Plug the USB (Type B) connector into the Kadex Interface.
The teleCARE IP system requires no configuration to support the Kadex Interface.
Note: The Kadex Interface connection is hot swappable and can be connected or
disconnected while the NIRC3 is running.
IMPORTANT: For Kadex system support, a room controller 3 (NIRC3) with software version
1.11.0 or later is required.
For detailed Kadex Interface mounting instructions refer to the Kadex documentation.
Kadex Connection Status
The status LED (Kadex logo) lights up to indicate the status of the Kadex Interface.
Kadex Interface
Status color
Steady red
Flashing red
Flashing green
Flashing blue
Steady blue
AG
Status
Kadex Interface Initializing
No connection to NIRC3
Attempting to setup a connection with the NIRC3
Connection to NIRC3 established
Connection to Kadex Server established
TD 92609FR
354
Publicité
