Accessory Compartment; Storing The Machine; Troubleshooting - Berkel 17074-0 Instructions Sur Le Fonctionnement

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 48
In the upper part of the machine there is a convenient Accessory Compartment (15) where you can
keep the Canister Tube (16) (fig. X3) and the Bag Cutter, manual Cutter (fig. X4).
When you are not using the machine, you can place it in a vertical position to reduce space. Proceed
as follows:
a) Insert the Power Cable (17) in the Cable Compartment (18) on the back of the machine (fig. W1).
b) Close the machine by rotating the Handles (1) to the STORAGE position (fig. W2 and W3).
ATTENTION: do not turn the Handles (1) to the START position because complete closure of the
machine when it is inactive for a long period of time could damage the Airtight Seal (7) causing a
leak in the Vacuum Chamber (8) and subsequent failure of the machine to work properly.
c) Place the machine in a vertical position far from heat sources (fig. W4).
Does not work
D oes not perform the
first seal on the piece
of cut roll
D oes not completely
vacuum-pack the bags

ACCESSORY COMPARTMENT

STORING THE MACHINE

TROUBLESHOOTING

• Make sure the power cable is fully inserted in the machine and in the electrical outlet.
Check the electrical outlet by trying another device in the same outlet.
• Make sure the power cable and/or plug is not defective. If so, do not use the
machine .
• Check that the piece of cut roll is correctly positioned as described in the paragraph:
"5 - Making bags from rolls". Check the position and integrity of the Sealing
Gasket .
• In order to correctly seal the bags, the open end must be entirely inside the Vacuum
Chamber (8). Check the correct position through the Lit WINDOW (3 ).
39

Publicité

Chapitres

Table des Matières
loading

Table des Matières