Packing In Family Canisters - Berkel 17074-0 Instructions Sur Le Fonctionnement

8.1- Packing in Executive Canisters
To pack with Executive Canisters or in canisters sealed with Universal Lids,
proceed as follows:
a) Refill the Canister leaving a space of at least 3 cm from the upper rim of
the canister and place the lid on the canister. Turn the Knob on the lid to the
"VACUUM" position (fig. Q).
b) Using the Canister Tube (16), connect the knob on the lid of the Canister to the
air intake ACCESSORY PORT (4) on the machine (fig. Q1)).
Please Note: at the beginning of the vacuum phase you may need to press down on the lids of some
types of canisters using your hand in order to hermetically seal them and make the cycle start easier.
c) Close the machine by rotating the Handles (1) to the START position (fig. Q2).
d) Press the "canister" button (2E) (fig. Q3 and Q4); the machine will perform the vacuum cycle
automatically and will shut off when the operation is complete. In any event, the pump turns itself
off automatically after about 5 minutes.
e) Detach the Canister Tube (16) from both the Canister Knob as well as the ACCESSORY PORT (4)
on the machine.
f) Turn the Canister Lid knob to the "CLOSED" position.
To open the canisters, turn the Lid Knob to the "OPEN" position; you should hear the air whistle
as it re-enters the canister. This sound is your guarantee that the contents were vacuum-packed.

8.2- Packing in Family canisters

Multi-use canisters, ideal for storing products that are used frequently like dry and fragile foods;
powdered foods; fruits and vegetables, fresh as well as blended or pureed; due to their transparency
and design, they are attractive on kitchen shelves and guarantee excellent visibility of their contents.
- Fill the Canister leaving a space of at least 3 cm from the upper rim of the canister and place the
lid on the canister.
- Using the Connection Tube (16), connect the canister lid to the air intake ACCESSORY PORT (4)
on the machine (fig. R1).
- Close the machine by rotating the Handles (1) to the START position (fig. R2).
- Press the canister button (2G) (fig R3 and R4), the machine will perform the vacuum in the
canister and will shut itself off once the operation is complete.
- Detach the Connection Tube (16) from the canister lid.
- To open the canisters, press the centre button and open the valve based on the model used (see
canister instructions).
36