Adding One/Several Osx8000 To One/Several Osu-9600 - JDSU OTU-8000 Manuel Utilisateur

Adding one/several OSX8000 to
one/several OSU-9600
5 Click on A onto the OSU/OSX Setup page of the Web Inter-
PPLY
face.
6 Confirm the address modification in the new dialog box pressing
OK.
7 Once completed, and if the addres has been successfully modified:
– a green text confirm the address modification.
– the LED Addr. onto the OSX8000 turns solid green
8 Press the Settings button again to complete the address modifica-
tion for OSX8000 multiplexer.
9 Follow step 2 to 4
the configuration of the following OSX8000.
The first OSX8000 set after the multiplexer will always have
address 1.
The addresses must be consecutive! (1, 2, 3, 4...).
10 Once all the OSX8000 are configured, you must launch a scan to
detect all the connected OSXs, clicking on the button F
11 Once scan is completed, the External Switches detection dialog box
is displayed with, for each OSX8000 address, its serial number and
C/P data.
– the OSX8000 Address 31, which represent the OSX8000 multi-
plexer, its serial number and C/P data
– the OSX8000 with addresses 1,2, 3 etc., which represent all the
OSX8000 connected to this multiplexer one, their serial numbers
and C/P data.
OSX distributor
Fig. 65 Scan results with one OSX8000 set as distributor
12 Click on the Switch tab to apply the configuration (see
the optical switch" on page
Once the OSU-9600 is/are configured (see
on page 48):
1 Add the OSX8000 into the rack
2 Disconnect the OTU-8000 <-> OSU-9600 cable (E98OTUXOSU)
on the OTU-8000.
3 Launch the addressing for each OSX8000
a Link the OTU to the first OSX8000 with the corresponding cable.
If the standard cable E98OTUXOSX is too short, use the longer
cable of 2.50 m.,available in the Kit E98OTUXOSU.
User Manual 7OTU80010/06
Chapter 3 Installation of the OTU-8000
from "OSX8000 in cascade mode" on page 50
58).
"Configuring the OSU-9600"
OTU-8000 and WEB Interface
for
S .
ULL CAN
"Configuring
53