Setting The Plexi Protector Onto The Otu-8000 - JDSU OTU-8000 Manuel Utilisateur

Chapter 3 Installation of the OTU-8000
Installation of the OTU-8000 into the rack
Setting the plexi protector
onto the OTU-8000
26
Fig. 20 OTU-8000 and bracket
Make the OTU-8000 slide to be sure it is correctly fixed.
The OTU-8000 is delivered with a plexi cover to protect the front side of
the equipment into the rack.
1 Set the two spacers on each side of the OTU-8000: manually turn
the spacer, then use a wrench 7 (Metric) or a wrench HS8 1/4''
(Inch) to fix it.
Mark for wrench
HS8 1/4'' (Inch)
Fig. 21 Spacer onto the OTU-8000
2 Fix the plexi protector onto the spacers, using the 2 milled or coun-
tersunk screws (see conditions of use for this screws chapter
of the delivered screws" page
Plexi Protector
Fig. 22

Setting the plexi protector onto the OTU-8000

User Manual 7OTU80010/06
2)
Fixing the cover
with milled screw
"Use