JDSU OTU-8000 Manuel Utilisateur page 84

Chapter 4 Web Interface
Exploitation
70
– Manual configuration: the parameters are configured by the user.
Auto Configuration
Fig. 88 Measurement parameters
Measurement parameters are as follows:
– OTDR type
– Acquisition Settings
– Wavelength
– Pulse Width
– Acquisition Time
– Range
– Resolution
1 Click on Start to run the measurement
2 Once the test or measure is completed, the trace is displayed.
Fig. 89 Measurement Result
The status Available is displayed in the Configuration box.
If the measurement has not been completed successfully, the status
Failed is displayed and no trace is visible.
1.Depending on the OTDR module being used
2.Can be modified exclusively in manual configuration
3., According to the module used
User Manual 7OTU80010/06
Manual Configuration
SM OTDR or MM OTDR
Auto Configuration / Manual Configuration
From 1310 to 1625 nm
2, 3
From 3 ns to 20 µs
In minutes and seconds
3
Up to 250km
3
From 4 cm
1