Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OSU-9600 additional hardware
Installation of the OSU-9600
Mounting the brackets for a 21''
or 23'' rack
OSX8000 (Internal schematic
view from above)
C
Optical switch module
Ports
1...36
1
36
Fig. 35
Configuration > 1x36 (up to 30 x 36)
The number of available optical ports may be increased thanks to one
1
or several OSU-9600
8000 in the racks" on page
The OSU-9600 comes with either 36 or 48 testing ports
common port.
The OSU-9600 is delivered with the 19'' brackets mounted on slides.
However, the brackets for 21'' or 23'' racks have been delivered if
required.
NOTE
Be sure you have a screwdriver and thread lock, to fasten the brack-
ets sufficiently.
To change the brackets onto the OSU-9600:
1 Remove the screws fixing the 19'' brackets onto the OSU-9600.
2 Remove the slides from the brackets 19'' and fix them onto the new
brackets to be used.
3 Set the brackets mounted on slides onto the OSU-9600, according
to the position wished:
a Standard position; the OSU-9600 is set ahead into the rack.
1.This module is an external OTAU
2. Depending of your order
User Manual
7OTU80010/06
Chapter 3 Installation of the OTU-8000
OSX8000 (Internal schematic
Up to 30...
1
C1
Optical Switch (Internal schemati, view from
Optical switch
module
1
. As seen in
"Overall dimensions of the OTU-
3, this module is not integrated in the OTU.
OSU-9600 additional hardware
view from above)
C
Optical switch module
Ports
1...36
C1
36
above)
C
n
C1
2
and one
35
Publicité
Chapitres
Table des Matières
