Functions Available With An Otdr Trace - JDSU OTU-8000 Manuel Utilisateur

Chapter 4 Web Interface
Exploitation
Functions available with an
OTDR trace
72
Example of configuration for measurement when OTU and Remote Optical
Switches are used.
Fig. 91 Example of configuration
If a measurement must be performed from the OTU-8000 to the Optical
Remote Switch 3 (dotted line Figure 91 page 72), configure the Optical
Path as follows:
Fig. 92 Optical Path configuration
NOTE
The Remote Switch numbers are defined according to the order in
which they have been registered in the Configuration page (see
page 58): the first remote switch registered is Remote Switch:1 etc.
Once the OTDR trace is displayed, several functions are available for
this trace.
Any modifications on the trace will not be saved. The actions on
trace are not kept in memory once trace is closed and re opened
(e.g. traces in overlay, traces in multi-window etc.).
Adding cursors
Click on to add cursors on the trace and display the information
corresponding to the pointed area (distance and loss).
The cursors data are displayed at the bottom of the screen.
User Manual 7OTU80010/06
Select OTU and all
Remote Switches