Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Chapter 3 Installation of the OTU-8000
Supply installation
Installation of the Female
Ground Connector
Installation of Ferrites
Procedure for switching on
and off the OTU-8000
28
Table 4
Pin Number
NOTE
The OTU-8000 cover panel clearly states the place of each wire to
connect above the male connector.
The OTU-8000 is equipped with a male ground connector. You need a
female clip (large: 6.3 mm / width: 0.8 mm), which will be set onto the
Male Ground connector, as described in the photo below.
Fig. 24
Female Ground Connector
The OTU is delivered with 2 ferrites to set onto the 48V supply cable:
1 Open the ferrite
2 Make 1 turn of the cables around the ferrite
3 Close the ferrite
4 Repeat the process for the second ferrite if another supply cable is
used.
Fig. 25
Ferrite and cable
As the OTU-8000 has been designed to function permanently, no
switch on and switch off buttons are offered. Nevertheless, a specific
procedure is required if you really need to switch on or off the OTU-
8000.
Switching on the OTU-8000
1 Plug the 5-pin connector.
2 Wait that the led Stand-by indicates that the switching on procedure
is completed, (about 3 minutes) (see
page
20).
User Manual
7OTU80010/06
Power supply connector pin-out
Function
5
Female ground
connector
Male ground
connector
"LEDs description" on
0
Publicité
Chapitres
Table des Matières
