Configuring The Osx8000 - JDSU OTU-8000 Manuel Utilisateur

Chapter 3 Installation of the OTU-8000
OTU-8000 and WEB Interface

Configuring the OSX8000

50
– the OSU-9600 with addresses 1,2, 3 etc., which represent all the
OSUs connected to this distributor one, their serial numbers and
C/P data.
OSU multiplexer
Fig. 58 Scan results with one OSU-9600 set as multiplexer
14 Click on the Switch tab to apply the configuration (see
the optical switch" on page
On the configuration menu, click on the OSU/OSX Setup tab. The
following page displays
Fig. 59 OSX8000 Setup
The OSX8000 can be configured differently:
– either all the OSX8000 are in cascade mode
– or one OSX8000 is set as distributor and the other are in cascade.
OSX8000 in cascade mode
1 Connect all the OSX8000 that can be connected to the OTU before
performing the configuration.
OSX8000 in cascade
Address 3
Address 2
Address 1
Fig. 60 Connection OTU-8000 <-> OSX8000 <-> OSX8000
User Manual 7OTU80010/06
58).
Command cable OSX <-> OSX
(Kit E98OSXXOSX)
Command cable OTU <-> OSX
(Kit E98OTUXOSX)
"Configuring