Configurations Of 1 Otdr And 36 Or 48 Ports; Configurations Of 2 Otdrs And 36 Or 48 Testing Ports - JDSU OTU-8000 Manuel Utilisateur

Configurations of 1 OTDR
and 36 or 48 ports
Configurations of 2 OTDRs
and 36 or 48 testing ports
The common port is located on the left of the front panel.
Common port
Stickers clearly state
Common, Port1, Port 2...
Fig. 37 OSU-9600 common and testing ports
The OSU-9600 replaces the OTAU plug-in. In this case, a blank plate
covers the place of the unnecessary module inside the OTU-8000.
1 Connect the OTDR plug-in to Common (on the OSU-9600) with the
supplied jumper.
2 Connect all fibers to be tested from the ODF to each port (1, 2...) on
the OSU-9600.
OTDR
Fig. 38 Configuration 1 x 36 and 1 x 48
The OSU-9600 comes in addition to the OTAU plug-in.
1 Connect the first OTDR plug-in to C1 in the OTAU with the first
supplied jumper.
2 Connect the second OTDR plug-in to C2 in the OTAU with the
second supplied jumper.
3 Connect the OTAU Port 1 to the OSU-9600 Common port.
4 Connect all fibers to be tested from the ODF to each port on the
OSU-9600.
User Manual 7OTU80010/06
Chapter 3 Installation of the OTU-8000
OSU-9600 additional hardware
OSU-9600 (Internal schematic
view from above)
Optical Switch Module
Ports 1 ...
36/48
Common
ODF
Connections
to do
37