Otau Ports; Connecting Ports - JDSU OTU-8000 Manuel Utilisateur

OTAU ports

Connecting ports

Switching off the OTU-8000
1 Keep pressing on the button Off for about 3 seconds to place the
OTU-8000 in Stand-by
2 Wait that the led Stand-by indicates that the switching off procedure
is completed, (about 30 seconds). For LEDs description, see
description" page 20.
3 Unplug the 5-pin connector.
The OTU-8000 houses a maximum number of 24 testing ports
additional hardware.
With no additional hardware, your configuration offers 2, 4, 8, 12, 16 or
2
24 ports .
NOTE
A front panel allowing 24 positions is used in all cases. Black caps
occupy unused ports for configurations with less than 24 testing ports.
Available ports are SC/APC type
panel via numbers.
One or two common ports are available on the right of the OTAU front
panel, according to your ordered configuration
a two common ports configuration allows two OTDR plug-ins to test the
same fibers.
Config. with 1 common
port (for one OTDR)
C1
Fig. 26 Location of Common ports
Case A: one OTDR is used
1 Use the supplied jumper to connect the OTDR to C1 (common port
#1).
1. The number of available testing ports has been ordered and configured in the factory.
2. Contact your sales representative if you wish to upgrade your configuration at some point.
3.Unless specified differently
4. The number of common ports usually varies according to the number of OTDR plug-ins in the
OTU-8000.
User Manual 7OTU80010/06
Chapter 3 Installation of the OTU-8000
3
and are clearly identified on the front
4
(see Figure
Config. with 2 common
ports (for two OTDR)
C1
+
C2
OTAU ports
"LEDs
1
without
26). Having
29