Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Chapter 3 Installation of the OTU-8000
OSX8000 additional hardware
OSX8000 additional hardware
Installation of the OSX8000
Mounting the brackets for a 21''
or 23'' rack
10 cm
32
The number of available optical ports may be increased thanks to one
or several OSX8000
in the racks" on page
The OSX8000 comes with 36 testing ports and one common port.
The OSX8000 is delivered with the 19'' brackets mounted on slides.
However, the brackets for 21'' or 23'' racks are delivered if ordered.
NOTE
Be sure you have a screwdriver and thread lock, to fasten the brack-
ets sufficiently.
To change the brackets onto the OSX8000:
1 Remove the screws fixing the 19'' brackets onto the OSX8000.
2 Remove the slides from the brackets 19'' and fix them onto the new
brackets to be used.
3 Set the brackets mounted on slides onto the OSX8000, according
to the position wished:
a Position1; the OSX8000 front panel is set at 10 cm from the rack
mounting.
b Position2: the OSX8000 front panel is set at 8 cm from the rack
mounting.
Position 1
Screw
Fig. 30
Brackets setting and position into the rack
1.This module is an external OTAU
User Manual
1
. As seen in
"Overall dimensions of the OTU-8000
3, this module is not integrated in the OTU.
8 cm
7OTU80010/06
Position 2
Screw
Publicité
Chapitres
Table des Matières
