Configurations Of 1 Otdr And 36 Ports; Configuration From 36 To 59 Fibers; Configuration With More Than One Osx8000 - JDSU OTU-8000 Manuel Utilisateur

Chapter 3 Installation of the OTU-8000
OSX8000 additional hardware
Configurations of 1 OTDR
and 36 ports
Configuration from 36 to 59
Configuration with more than
one OSX8000
34
The OSX8000 replaces the OTAU plug-in. In this case, a blank plate
covers the place of the unnecessary module inside the OTU-8000.
1 Connect the OTDR plug-in to Common (on the OSX8000) with the
supplied jumper.
2 Connect all fibers to be tested from the ODF to OSX8000 ports.
Fig. 33
1 Connect C1 from the OSX8000 to port n of the internal optical
fibers switch.
2 Connect all fibers to be tested from the ODF to OSX8000 ports.
Fig. 34
1 Connect C1 from the first OSX8000 to port 1 of the internal optical
switch.
2 Connect C1 from the last OSX8000 to port n of the internal optical
switch.
3 Connect the OTU to the first OSX, the first OSX to the second one,
the second one to the third one etc., using command cables.
4 Connect all fibers to be tested from the ODF to OSX8000 ports.
User Manual
OTDR
Common
Configuration 1 x 36
OSX8000 (Internal schematic
view from above)
Optical switch module
Ports
1...36
1
Optical Switch (Internal schemati, view from
above)
C
Optical switch
module
n
1
Configuration one OTAU and one OSX8000
7OTU80010/06
OSX8000 (Internal schematic
view from above)
Switch
Ports 1...36
ODF
C
C1
36
OTDR
C1