JDSU OTU-8000 Manuel Utilisateur page 87

Zoom on trace
The icons
content on the trace.
Adding / Removing a trace
Several OTDR traces can be displayed in overlay. To do so:
1 Click on the icon
2 Select the trace to be displayed in overlay with the current one
3 Click on OK to validate.
Both traces will be displayed in overlay.
To remove one of the trace:
1 Select it on the left window
2 Click on the icon
Even if only one trace is opened, by clicking on the icon
Remove Trace will automatically remove the trace from the
display.
Traces in multi-window mode
To display traces in multi-window mode:
1 Click on .
2 Select the trace to be displayed in multi-window with the current
one.
3 Click on OK to validate.
Both traces will be displayed in two windows.
Results table
1 To display the results table for the current trace, click on
A results table for the active trace will be displayed under the trace.
When several traces are displayed in overlay, select the trace for which
the table must be displayed by clicking on the corresponding radio
button.
Saving the OTDR trace
1 Click on the icon
2 Select the directory in which it will be saved and click on OK.
No actions on the current trace via the Web Interface (traces in
overlay, position of cursors etc.) will be saved.
Exporting the trace allows to analyze it using JDSU softwares
such as Fiber Trace and Fiber Cable.
User Manual 7OTU80010/06
allow respectively to zoom in, zoom out and fit to
. The trace is removed from the display.
to save the trace on the computer.
Chapter 4 Web Interface
Exploitation
.
73