Performing A Measurement On A Fiber; Performing A Measurement With An Otu-8000 And Optical Remote Switch(Es) - JDSU OTU-8000 Manuel Utilisateur

Unité de test optique rackable pour rfts
Masquer les pouces Voir aussi pour OTU-8000:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Performing a measurement
on a fiber
Performing a measurement with
an OTU-8000 and Optical
Remote Switch(es)
To perform a measurement on a fiber:
1 Click on Measurement, in the left menu.
2 Configure the measurement parameters as seen in
3 Click on
Start
to launch the measurement.
Once the measurement is completed, the corresponding trace is
displayed.
Fig. 90
Measurement trace
The status Available is displayed in the configuration box.
If the test or measurement has not been completed successfully, a
failure status is displayed and no trace is visible.
Once the OTU-8000 is correctly configured with the Remote Optical
Switch, you can perform a measurement on fibers.
1 Click on Measurement, in the left menu.
2 In the field Optical Path:
a Select the OTU and the Remote Optical Switch(es) for the measure-
ment by clicking on the corresponding checkboxes on the right.
b For OTU and Remote Switch, select from the list the output switch (the
input switch is set to 01 by default and must be kept)
3 Configure the other measurement parameters as wished (see
page
70).
4 Once all parameters are correctly defined, press S
the measurement.
User Manual
7OTU80010/06
Chapter 4 Web Interface
Exploitation
page
70.
to launch
TART
71

Publicité

Chapitres

Table des Matières
loading

Table des Matières