Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Chapter 3 Installation of the OTU-8000
Installation of the Launch Fiber Module
Installation of the Launch Fiber Module
Installation of the Launch
Fiber into the module
40
The OTU-8000 can be equipped with a Launch Fiber Module, usually
set above the OTU-8000.
Fig. 43
Launch Fiber Module to place above the
NOTE
This module is used to get default visibility at the very beginning of the
fiber to test (the launch fiber is in the dead zone, not the fiber to test).
You must use a Torx Screwdriver to install the Launch Fiber into the
Module
1 Open the Launch Fiber Module by unscrewing the 4 Torx screws of
the upper cover.
Use a screwdriver to remove upper cover.
Fig. 44
Removing upper cover
2 Set the Launch Fiber reel into the box, and fix it with the screws.
Fig. 45
Installation of the Fiber Launch
User Manual
7OTU80010/06
Set screws for the launch fiber reel
OTU-8000
Publicité
Chapitres
Table des Matières
