Configuring The Relay - JDSU OTU-8000 Manuel Utilisateur

Configuring the Relay

Fig. 75 Switch configuration when a different switch has been
detected
If the two configurations do not match
Click on the button A
PPLY
registered configuration with the detected one.
Once the detection is completed, the page is displayed as follows:
Fig. 76 Switch configuration valid (example with one OSX8000
configured as distributor)
NOTE
If the page displays a registered configuration but no detected hard-
ware, you must apply the modifications (this is the case if you remove
the switch).
The Relay tab allows to configure whether relays should be open or
close according to the alarm type.
Fig. 77 Relay configuration
1.This can happen if you replace, add or remove the optical switch for example
User Manual 7OTU80010/06
Chapter 3 Installation of the OTU-8000
1
, differences are displayed in red.
D S then
ETECTED WITCH
OTU-8000 and WEB Interface
OK to match the
OSX used as
distributor
59