Siemens simovert masterdrives CBP/CBP2 Mode D'emploi page 119

SBM – Sensor Board Encoder / Multiturn (only for MASTERDRIVES Motion Control)
View of the SBM
WARNING
View of the SBM2
NOTE
9-2
System connector
Fixing screw
Fig. 9-1 View of the SBM optional board
The hook switches S1 and S2 are for adjusting the encoder supply
voltage.
Switch S1 Switch S2
open
open closed
closed closed
An incorrectly set supply voltage can cause damage to the encoder!
System connector
Fixing screw
Fig. 9-2 View of the SBM2 optional board
The encoder supply voltage can be adjusted on the SBM2 optional
board by means of parameters.
S2
S1
Voltage
open 5 V
7,5 V
15 V
6SE7087-6NX84-0FF5
Option boards
05.2006
Fixing screw
X424 (connector)
25-pole Sub-D connection
Encoder with KTY/PTC
X420
Pulse encoder simulation
(factory setting)
Fixing screw
X424 (connector)
25-pole Sub-D connection
Encoder with KTY/PTC
X420
Pulse encoder simulation
Siemens AG
SIMOVERT MASTERDRIVES