Installation; Connecting-Up - Siemens simovert masterdrives CBP/CBP2 Mode D'emploi

CBC – Communication Board CAN-Bus
3.3

Installation

NOTE
3.4

Connecting-up

X458, X459
1 5
6 9
9 6
5 1
X458 X459
3-2
If the inverters/converters are ordered with optional functions, the
optional boards are already installed in the units when they are
delivered.
It is possible to retrofit optional boards and this can be carried out by
the user.
For this purpose, there are either three or up to six slots on the basic
unit depending on the type of construction for mounting the optional
boards.
An exact description of installation is included with the relevant basic
unit. As the unit has to be removed and opened in order to install
optional boards, attention must be paid to the ESD measures. Please
refer to the operating instructions of the basic unit in this regard.
Generally, you can install the CBC optional board (communication
board CAN) in every slot. However, bear in mind that a sensor board
always requires slot C.
One CBC can be installed per unit.
The CBC optional board has a 9-pole Sub-D connector (X458) and a 9-
pole Sub-D socket (X459) which are provided for connecting it up to the
CAN bus.
The two connections have identical assignment and are through-
connected internally; they are short-circuit-proof and floating.
Pin Designation
1 -
2 CAN_L
3 CAN_GND
4 -
5
6 CAN_GND
7 CAN_H
8 -
9 -
Table 3-2 Connections X458 (socket) and X459 (pins)
Significance
Not connected
CAN_L bus line
CAN ground (M5)
Not connected
Not connected
CAN ground (M5)
CAN_H bus line
not connected
not connected
6SE7087-6NX84-0FF5
Option boards SIMOVERT MASTERDRIVES
05.2006
Siemens AG