Safety; You Should Pay Attention To This; Transport - Kollmorgen AKM 2G Manuel D'installation

1.2 Safety

This section helps you to recognize and avoid dangers to people and objects.

1.2.1 You should pay attention to this

Specialist staff required!
Only properly qualified personnel are permitted to perform such tasks as transport, assembly, setup
and maintenance. Qualified specialist staff are persons who are familiar with the transport, installation,
assembly, commissioning and operation of motors and who bring their relevant minimum qualifications
to bear on their duties:
Transport: only by personnel with knowledge of handling electrostatically sensitive components.
l
Mechanical Installation: only by mechanically qualified personnel.
l
Electrical Installation: only by electrically qualified personnel.
l
Setup: only by qualified personnel with extensive knowledge of electrical engineering and drive
l
technology
The qualified personnel must know and observe IEC 60364 / IEC 60664 and national accident
prevention regulations.
Read the documentation!
Read the available documentation before installation and commissioning. Improper handling of the
motor can cause harm to people or damage to property. The operator must therefore ensure that all
persons entrusted to work on the motor have read and understood the manual and that the safety
notices in this manual are observed.
Pay attention to the technical data!
Adhere to the technical data and the specifications on connection conditions (rating plate and
documentation). If permissible voltage values or current values are exceeded, the motors can be
damaged, for example by overheating.
Perform a risk assessment!
The manufacturer of the machine must generate a risk assessment for the machine, and take
appropriate measures to ensure that unforeseen movements cannot cause injury or damage to any
person or property. Additional requirements on specialist staff may also result from the risk
assessment.
Transport safely!
Lift and move motors with more than 20 kg weight (AKM2G7) only with lifting tools. Lifting unassisted
could result in back injury. Always observe the hints on
Secure the key!
Remove any fitted key (if present) from the shaft before letting the motor run without coupled load, to
avoid the dangerous results of the key being thrown out by centrifugal forces. When delivered, the key
is protected with a plastic cap.
Hot surface!
The surfaces of the motors can be very hot in operation, according to their
protection category. Risk of minor burns! The surface temperature can exceed
100°C. Measure the temperature, and wait until the motor has cooled down below
40°C before touching it.
AKM2G Instructions | 1 English

Transport

Kollmorgen | kdn.kollmorgen.com | August 2020 5