Recommissioning After Storage; Service And Care; Disposal And Environmental Protection - DT SWISS F 232 ONE Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31
6. HANDLING
6.1 TRANSPORT
Careful transport avoids damage to the fork. The stanchions in particular must be protected from
damage.
6.2 STORAGE (> 1 MONTH)
Careful storage prolongs the life of the fork. Note the following points:
• Reduce the air pressure.
• Clean the fork and control elements.
• For the remote version, release the tension of the cable strain in order to prevent wear.

6.3 RECOMMISSIONING AFTER STORAGE

1. Invert the fork.
→ The lubricating oil runs from the lower section of the fork over the bushings, therefore
lubricating them.
2. Gently compress the fork a few times.
→ The lubricating oil is distributed.
3. Check the air pressure in the spring element and adjust it as necessary (see "4.1 Adjusting the air
pressure" on page 24).
4. Actuate the control elements several times.
→ The oil is distributed over the seals.
5. Check all of the functions of the fork.
→ If there are any malfunctions, contact the DT Swiss Service Center.

7. SERVICE AND CARE

Task
Service completed by a DT Swiss Service Center
Small service (to be completed by a DT Swiss Service Center
if necessary): refer to the Technical Manual available at www.
dtswiss.com
Check fork for damage and cracks.
If there is any damage, contact the DT Swiss Service Centre.
Check the fastening is correct / check tightening torques
Check the functionality
Clean with a soft sponge and a suitable cleaning agent,
especially in the area around the wiper seals.
Do not use high pressure cleaners or aggressive cleaning
agents!

7.1 DISPOSAL AND ENVIRONMENTAL PROTECTION

The statutory regulations shall apply. Whenever possible, avoid creating waste. Waste, especially
carbon, lubricants, cleaners and any other fluids must be disposed in an environmentally compatible
manner.
F 232 ONE - User Manual V2021.09
Interval
Annually or after 200 operating
hours
50 operating hours
more frequently in case of extreme
operating conditions.
Before and after every ride
and after a crash
Before each ride
Before each ride
After each ride
29

Publicité

Table des Matières
loading

Table des Matières