DT SWISS F 232 ONE Manuel D'utilisation page 25

REDUCING THE AIR PRESSURE
1. Set the fork to "OPEN" mode (see "4.2 Setting the riding mode" on page 26).
2. Unscrew the valve cap.
3. GRADUALLY press the valve insert with the back of the valve cap.
or
Screw on the shock pump and SLOWLY reduce the air pressure by pressing the release valve on
the shock pump.
4. With the shock pump attached, slowly compress the fork twice by about 10 mm and then
decompress fully.
→ This equalizes the positive and negative air chambers.
→ Once the pressure displayed on the shock pump stops changing after compression, the two air
chambers have equalized.
5. Repeat steps 3 and 4 until the desired pressure is displayed on the shock pump after compression.
6. Unscrew the shock pump and screw the valve cap onto the valve.
F 232 ONE - User Manual V2021.09
25