DT SWISS F 232 ONE Manuel D'utilisation page 21

3.5 MOUNTING THE BRAKE HOSE HOLDER
1. Click the brake hose holder onto the brake hose.
2. Insert the brake hose holder with the brake hose
clicked in into the mounting hole on the fork
bridge.
3. Insert the screw through the fork bridge from
behind, screw it into the brake hose holder and
tighten with a torque of 1 Nm.
4. Make sure that the brake hose does not touch
the fork crown during operation and does not
impair the function of other components.
3.6 FITTING THE FENDER
1. Attach the fender to the rear of the fork bridge.
2. Insert both fixing screws and tighten them to
1.5 Nm.
ATTENTION: Do not exceed the specified tightening
torque of the fixing screw under any circumstances!
This can damage the fork threads beyond repair.
F 232 ONE - User Manual V2021.09
21